Roller Veneer Drying Machine-manufacture,factory,supplier from China

The veneer peeling machine and knife grinding machine recently purchased by our Ugandan customers are now finished and ready to be shipped. Thank you for your trust in us. In addition to the veneer peeling machine, we also specialize in the production of biomass burner veneer dryers. If You are welcome to consult us at any time if you need it.

Why suggest you to choose Shine biomass burner roller veneer dryer ? 1. The biomass burner, a patented product independently developed by our company, can directly use crushed wood waste as fuel to provide a heat source for the dryer, no need to buy steam boiler or thermal oil again . which is energy-saving and environmentally friendly, and greatly reduces the drying cost. The comprehensive drying cost for one cbm is about $10 lower than thermal oil or steam boiler. 2.

Since its establishment in 1999, Shine Machinery has always adhered to the development concept of continuous innovation and provided excellent solutions for customers.At present, our largest roller veneer dryer has been installed and runs smoothly in South Africa, capable of drying approximately 230 cubic meters of veneer in 24 hours.Recently, our 6-layer and 6-meter wide veneer dryer has also unveiled its mysterious veil. Currently, research and development are progressing smoothly, with an expected hourly output of around 15-18 cubic meters, which will further enhance the user experience.

Xishuangbanna customers ordered two set  58 meters 4.5 meters wide double layer  roller veneer dryer ,which use thermal oil as fuel . They two veneer dryers were installed well and put into use successfully . they will dry the rubber veneers and welcome to visit and give suggestion. 

The Brazilian customer bought our 24m single-layer veneer drying equipment with our patented biomass burner,  the customer feedback that our equipment is very good, it can  achieve the expected output and  dried veneer moisture content is even, flat, no wrinkles.We have a professional R&D team that can design different models according to customer’s special requirement.

Shine fully automatic 4 layer roller veneer dryer put into production in Guangdong recently . With automativ veneer feeding device and automatic veneer collection machine , big capacity plywood veneeer drying machine can save labor cost to the most .

The veneer dryer needs to pay attention to some problems when drying wood. Before use, the heating fan should be started first, and when the drying temperature is reached, the speed regulating motor should be started. The veneer should enter from the feeding port longitudinally, the feeding should be straight, the veneer and the transmission roller should be connected at a 90-degree angle, and the veneer should be cut neatly before drying.

We have extensive experience in drying rubber wood veneer. Our dryer has the advantages of low card rate and easy maintenance of equipment.Reasonable roller diameter and roller spacing not only ensure that hot air can be evenly distributed on both sides of the veneer, but also greatly reduce the occurrence of veneer jamming. At the same time, the ellipticity of the roller does not exceed 100 um, and the straightness does not exceed 500 um, which also reduces the occurrence of jamming.

Recently, our Six-deck Roller Veneer Dryer carryed on a test run, and Peruvian customer visited the testing site. At present, the R&D work is progressing smoothly, and the new generation of automatic veneer loading machine meets expectations. The new dryer will undergo a fully automated upgrade to reduce labor costs while ensuring efficient and stable drying. It is expected to produce around 15-18 cubic meters per hour.

The Vietnamese customer's 40-meter single-layer veneer drying equipment is being installed. Due to the impact of the epidemic, the engineer cannot go to the site to install it. We will guide the customer to complete the installation smoothly through the video, and thank the customer for their recognition of our products.